Measurements For Glass Staircases With Clamps

Once your staircase has been installed we will require the opening sizes of your landing areas. Please use the measuring guides attached to give us the information we require to order your glass.

Please email your measurements to:

glass.sizes@pearstairs.co.uk

Your rake and landing glass will be delivered at the same time.

We do not require any measurements for the rake glass on your staircase.

 
GLASS BRITISH KITE MARK LOCATION

The British Standard Kite Mark (right) must be engraved into each pane of glass. The mark is approximately 25mm in diameter when placed onto the front of a glass
panel. There are two options for positioning the engraving, seen below.

PLEASE NOTE: The mark is required to be visible for building inspections If the glass must be removed for an inspector to view the mark, Pear Stairs will take no responsibility for the removal of the glass or any costs or damages that may be incurred in doing so.

Once your staircase has been installed we will require the opening sizes of your landing areas. Please use the measuring guides attached to give us the information we require to order your glass.

Please email your measurements to:

glass.sizes@pearstairs.co.uk

Your rake and landing glass will be delivered at the same time.

We do not require any measurements for the rake glass on your staircase.

Glass Sizes For Balustrade With Glass And Clamps 

How to measure the measurements for glass staircases with clamps.

Using the diagram above as a guide, you will need to measure the dimensions of both ‘X’, from post face to post face, and ‘Y’, the top of the base rail to the bottom of the handrail.

Both of these measurements should be provided in ‘mm’ and be sent to glass.sizes@pearstairs.co.uk


Glass Sizes For Return Balustrade With Glass And Clamps

Measuring glass sizes for staircases with clamps on a return balustrade.

Using the diagram above as a guide, you will need to measure the dimensions of both ‘X’, from post face to post face, and ‘Y’, the top of the base rail to the bottom of the handrail.

Both of these measurements should be provided in ‘mm’ and be sent to glass.sizes@pearstairs.co.uk

GLASS BRITISH KITE MARK LOCATION

The British Standard Kite Mark (right) must be engraved into each pane of glass. The mark is approximately 25mm in diameter when placed onto the front of a glass panel. There are two options for positioning the engraving, seen below.

Where to position the British Kite Mark on glass panels in order to meet building regulations.

PLEASE NOTE: The mark is required to be visible for building inspections If the glass must be removed for an inspector to view the mark, Pear Stairs will take no responsibility for the removal of the glass or any costs or damages that may be incurred in doing so.